來源:網絡資源 2023-07-06 21:19:47
溶液稀釋的表示
1、溶質質量分?jǐn)?shù):
溶質的質量與溶液質量的比值叫做溶質的質量分?jǐn)?shù)。
2、表達式:
溶質的質量分?jǐn)?shù)=(溶質質量/溶液質量)*100% = [溶質質量/(溶質質量+溶劑質量]*100%
3、關系式:
溶質的質量=溶質的質量分?jǐn)?shù)*溶液質量=(溶質質量+溶劑質量)*溶質質量分?jǐn)?shù)
注意:
①溶質的質量分?jǐn)?shù)一般用百分?jǐn)?shù)表示。
②溶質、溶劑、溶液量均以質量為單位表示,單位要統一
③溶質質量是指全部溶解在溶劑中的質量,不包括未溶解的或結晶析出的物質的質量
④某溫度下,溶劑或溶液中加的溶質超過飽和狀態時,所得溶液的最大濃度可以用該溫度下的溶解度求,
溶質的質量分?jǐn)?shù)=(S/S+100)*100%=【已溶解的量/(溶劑質量+已溶解的溶質質量)】*100%
2、溶液的稀釋和增濃問題:
(1)關于溶液的稀釋計算:因?yàn)橄♂屒昂笕苜|(zhì)的質量不變,所以若設濃溶液質量為Ag,溶質的質量分?jǐn)?shù)為a%,加水稀釋成溶質質量分?jǐn)?shù)為b%的稀溶液Bg,則Ag×a%=Bg×b%其中B=A+m水
(2)溶液增濃的計算
①向原溶液中添加溶質:設原溶液質量為Ag,溶質的質量分?jǐn)?shù)為a%,加溶質Bg后變成溶質質量分?jǐn)?shù)為b%溶液,則Ag×a%+Bg=(Ag+Bg)×b%
②將原溶液蒸發掉部分溶劑:因?yàn)槿芤赫舭l(fā)溶劑前后,溶質的質量不變。所以若設原溶液質量為Ag,溶質的質量分?jǐn)?shù)為a%,蒸發Bg水后變成溶質質量分?jǐn)?shù)為b%溶液,則
Ag×a%=(Ag-Bg)×b%
③與濃溶液混合:因?yàn)榛旌衔锶芤旱目傎|(zhì)量等于兩混合組分溶液的質量之和;旌虾蟮娜芤褐腥苜|(zhì)的質量等于兩混合組分的溶質質量之和。所以設原溶液質量為Ag,溶質的質量分?jǐn)?shù)為a%,濃溶液的質量為Bg,溶質質量分?jǐn)?shù)為b%,兩溶液混合后得到溶質的質量分?jǐn)?shù)為c%的溶液,則Ag×a%+Bg×b%=(Ag+Bg)×c%
注意:
溶液的質量和體積換算:密度=質量/體積
編輯推薦:
歡迎使用手機、平板等移動設備訪問中考網,2023中考一路陪伴同行!>>點擊查看